Description
The AiM EPM32 adds 32 controlled power outputs to a compatible AiM dash or PDM. It's the bigger brother to the EPM08, built for full race car electrical systems where you want every pump, fan, light, and accessory switched, protected, and monitored from one box.
Each output is fused electronically, so there are no relays or fuse panels to wire. Over current, short circuit, over and under voltage, and over temperature protection are built in, and every output has its own RGB status LED. Setup happens in Race Studio 3, where the EPM shows up as an expansion: you assign outputs, alarms, icons, and commands, then watch each channel's current and status live.
Ideal for: Complex race car electrical systems, and for adding a large number of power outputs to an existing MXS, MXP, MXG, MXT, or SW4 setup without replacing it.
Key features:
- 32 power outputs, up to 120 A total: 4 at up to 35 A (configurable as high side, low side, or half bridge), 4 at up to 20 A (one with a series diode), 12 at up to 15 A, and 12 at up to 10 A
- Up to 8 analog inputs, recorded at up to 500 Hz, plus digital inputs
- 32 RGB output LEDs plus ON and status LEDs
- Over voltage, under voltage, short circuit, over current, and over temperature protection
- 2 AMP connectors and 1 Amphenol Surlok power connector
- IP67 rated anodized aluminum body, 234.4 x 95.1 x 49.0 mm, 740 g
- Configured in Race Studio 3 (version 3.81.00 or later)
- Available as module only, or with a 200 cm or 400 cm CAN cable
Save hours on the install. Don't forget to look at our PDM32 Plug and Play Wiring Harness, a TrailBrake exclusive with genuine AMP connectors terminated, booted, and labeled so you skip building the harness yourself. Want it even cleaner? The PDM32 Plug and Play Terminated Harness adds a sealed, concentrically twisted harness with DT connectors.
Need fewer outputs? The EPM08 gives you 8 outputs (up to 100 A total) in a smaller package. More info can be found here.
Compatibility. The EPM08/EPM32 works with the AiM SW4, MXS 1.3, MXP 1.3, MXG 1.3, MXT 1.3, PDM8 and PDM32.